Product Safety Information; Product Specifications - Ingersoll Rand EC300 Spécifications Du Produit

Product Safety Information

Intended Use:
It is designed to cut mild steel, aluminum, tin and other materials up to 18 gauge (1.2 mm).
For additional information refer to Product Safety Information Manual Form 04580494.
Manuals can be downloaded from iredge.com.

Product Specifications

Free
Speed
Model
Strokes/min.
EC300 4200
† K = 3dB measurement Uncertainty
pA
‡ K = 3dB measurement Uncertainty
wA
* K = Vibration measurement Uncertainty
Installation and Lubrication
Size air supply line to ensure tool's maximum operating pressure (PMAX) at tool inlet. Drain
condensate from valve(s) at low point(s) of piping, air filter and compressor tank daily. Install
a properly sized Safety Air Fuse upstream of hose and use an anti-whip device across any
hose coupling without internal shut-off, to prevent hose whipping if a hose fails or coupling
disconnects. See drawing 16578551 and table on page 2. Maintenance frequency is shown in a
circular arrow and defined as h=hours, d=days, and m=months of actual use. Items identified as:
1. Air filter
2. Regulator
3. Lubricator
4. Emergency shut-off valve
5. Hose diameter
Parts and Maintenance
When the life of the tool has expired, it is recommended that the tool be disassembled,
degreased and parts be separated by material so that they can be recycled.
Original instructions are in English. Other languages are a translation of the original instructions.
Tool repair and maintenance should only be carried out by an authorized Service Center.
Refer all communications to the nearest Ingersoll Rand Office or Distributor.
47507209_ed2
Max. Material
Thickness
Gauge/Inch/mm † Pressure (L
18/.05/1.2
6.
7.
8.
9.
10. Grease - during assembly
Sound Level dB(A)
(ISO15744)
) ‡ Power (L
p
96.4 107.4
Thread size
Coupling
Safety Air Fuse
Oil
EN
Vibration (m/s²)
(ISO28927)
) Level *K
w
19.6 2.3
EN-1