Outside Mount; Operating The Shade - Levolor Motorized Lift Control-Open Roll Manuel D'installation

INSTALLATION
OUTSIDE MOUNT (OM)
STEP 1: MARKING THE BRACKET LOCATIONS
IMPORTANT: The brackets must be flush against
a flat mounting surface. Do NOT mount brackets
on curved molding.
•
Center the shade over the window
opening at the desired height.
•
Mark screw location for each end
bracket, 2 holes per bracket.
— Use a level to ensure all
brackets are aligned.
STEP 2: INSTALLING THE BRACKETS
•
Pre-drill screw holes using a
pencil marks as a guide.
— If installing brackets into
wood, use supplied screws.
— If installing into drywall or
other, use anchors in
combination with
supplied screws.
•
Screw in brackets at marked
locations, 2 screws per bracket.
— Bracket with attached circular
mount should be on left side
(idle side).
— Bracket with attached slots should be on right side (motor side).
•
Ensure all brackets are square with each other.
•
Slide bracket end cap over bracket on left side to prepare for shade installation.
CAUTION: Be sure the brackets are properly engaged before
!
operating the shade. Failure to do so may result in the shade
falling and possible injury.
8
Motorized Lift Control–Open Roll
⁄ " drill bit, using
1
16
Drywall
Drywall
Anchor
Anchor
Bracket
Bracket
Bracket
Bracket
Screw
Screw