Installing The Cooktop - GEA JGP628 Instructions D'installation

INSTALLING THE COOKTOP

PROVIDE ADEQUATE
1
GAS SUPPLY
This cooktop is designed to operate on
natural gas at 4" of water column pressure.
It is shipped from the factory set for natural
gas. The convertible pressure regulator
supplied with the unit must be connected in
series with the manifold of the cooktop and
must remain in series with the supply line
regardless of whether natural or L.P. gas is
being used. FOR PROPER OPERATION,
THE MAXIMUM INLET PRESSURE TO THE
REGULATOR MUST BE NO MORE THAN
14" OF WATER COLUMN PRESSURE. For
checking the regulator, the inlet pressure
must be at least 1" (or 3.4 KPA) greater than
the regulator output setting. If the regulator is
set for 4" of water column pressure, the inlet
pressure must be at least 5". If the regulator
is set for 10", the inlet pressure must be at
least 11". The gas supply line to the cooktop
should be 1/2" or 3/4" pipe.
INSTALL REGULATOR
2
NEVER REUSE OLD CONNECTORS WHEN
INSTALLING THIS COOKTOP.
WARNING:
flexible connectors. The use of old flexible
connectors can cause gas leaks and personal
injury. Always use new flexible connectors
when installing a gas appliance.
Screw a section of pipe
onto each end of the
pressure regulator.
To reduce the likelihood of gas leaks, apply
teflon tape or a thread compound approved
for use with LP or Natural gases to all
threaded connections.
Installation Instructions
Never reuse old
Pressure
Regulator
INSTALL REGULATOR ONTO
3
BURNER BOX BOTTOM
Screw the
regulator and
pipe connection
into the burner
box bottom.
Make sure the
top of the
regulator is
facing towards
the cabinet front,
easily accessible
through the
cabinet doors.
COMPLETE CONNECTION
4
WITH A COUPLING
Install a coupling
between the
regulator and
the shu-off valve
to complete the
connection.
6
Pressure
Regulator
Shut-Off
Electrical
Valve
Outlet 12"
Below
Countertop
Pressure
Regulator
Coupling
Shut-Off
Electrical
Valve
Outlet 12"
Below
Countertop