Cleaning And Maintenance - Rocal Habit 80 DC +T Manuel Des Caracteristiques, Installation Et Fonctionnement

registers open for a reasonable time to prevent condensation on the door. When the apparatus is hot enough close the
door, adjust the primary register to avoid excessive combustion and control the intensity of fire by the child record.
IMPORTANT: -The interior vermiculite parts SHOULD NOT RECEIVE IMPACTS when refueling is
performed.
If any of these parts crack, but is properly set in its place, THE PROPER OPERATION OF
THE APPLIANCE SHALL NOT BE ALTERED AND THERE IS NO POTENTIAL RISK. The
equipment can be used normally. These cracks do not entail any manufacturing defect so
they do not fall under guarantee.
4.5 Loading and reloading of fuel. Do not exceed the maximum allowed load or reload. (See Table of Technical
specifications).
4.6 Door opening. The door must be opened only for reloading. To open it, follow the steps described in picture "D.1"
on page 9 of the ANNEXED document.
4.7 Operation in adverse weather conditions. It is possible for the device to malfunction due to sudden or unexpected
weather changes, causing: low pressure, ebb currents of air into the smoke duct. When these phenomena are observed
it is advisable to close the combustion register and turn the equipment off.
4.8 Fire Prevention. You must not place any flammable element outside the safety distance from the fireplace described
in the table in section 1.1 Technical specifications. You shall also take special precautions if there are children and
elderly people present. In case of fire, push away all the people around it, close the registers as much as possible and
notify the Firefighting service.
4.9 Dilations of the sheet. Materials subject to temperature changes undergo dilatations. This phenomenon can cause
sporadic metallic noises more or less frequently. These are completely innocuous and do not mean any risk or problem
for its operation.

5. CLEANING AND MAINTENANCE

5.1 Maintenance. An appropriate and regular maintenance of both the appliance and the installation contributes greatly
to its good performance. It is important to perform periodic and complete controls of the equipment and of the ducts and
installation. Thus, for your safety and comfort, some of our dealers offer a servicing contract for your device. Please
contact your dealer for this service.
5.1.1 Locking mechanisms. You need to make sure no mechanisms are locked (registers, door, air inlet, etc.) after an
extended shutdown period.
5.1.2. Spare parts. Use only original spare parts, or parts recommended by Manufacturas Rocal, S.A. See picture on
page 14 of the ANNEXED document.
5.2. Cleaning. It is important for the appliance to be clean of ash so that all mechanisms work properly. To clean the
body of the device use the cleaning dry cloth given with the appliance or similar. Do not use current cleaning
products.
5.2.1 Glass. You must turn the device off to clean the glass. The products used must not come into contact with the
metal parts of the door or the ceramic board; the aggressiveness of these products can cause a corrosion process of
the equipment.
5.2.2 Extraction of ashes. Extract the ashes only when the appliance is completely turned off, ensuring that the ashes
do not contain any burning coals; in which case you should deposit them in a metal bucket.
5.2.3. Flue liner. It is important to keep the flue liner clean. It gets dirty depending on the fuel used, on a slower or
faster combustion, etc. You need to clean the flue liner at least once per season. It is mandatory for a specialist to review
it periodically. To access the flue liner follow the steps shown in pictures "D.9", "D.10" and "D.11" of the ANNEXED
document.
5.2.4. Painting. The heatproof paint that covers the inside and outside of the appliance withstands temperatures up to
600 °C and releases a subtle typical smell that disappears after the first few uses.
It is possible for the paint to jump out in some areas inside the housing after a period of use, due to corrosion caused
by liquids, inadequate fuel types or others not authorized by the manufacturer, etc., In that case it will be necessary to
repaint all damaged areas before a prolonged shutdown period. Use exclusively "Rocal heatproof spray paint".
6. OPTIONAL COMPLEMENTS
Rocal offers various optional items, contact your local dealer to purchase these items. Some of the items are shown
below:
Item
ECOntrol
Log store
Log store HABIT
BENCH
Ash vaccum cleaner
Code
C7000
C1000
ASPIRADOR
Description
Intelligent combustion control
11