Checking For Blockages - shark Rocket HV300 Guide Du Propriétaire

MAINTAINING YOUR VACUUM - Continued
TIP: Ensure the bottom of the floor
nozzle is completely sealed and locked
before using�
TIP: You do not need any tools to open
the floor nozzle, just a coin�
15
s h a r kc l e a n . c o m

CHECKING FOR BLOCKAGES:

HANDHELD AND WAND
1 Remove the wand from the
handheld vacuum and check all
dust cup intake openings�
2
Remove the floor nozzle from the
wand and check the wand for
blockages�
BOTTOM OF FLOOR NOZZLE
1
Use the edge of a coin to open the
three locks on the bottom of the
floor nozzle�
3
Run scissors along the groove in
the brushroll to cut or clear away
any string, carpet fibers, hair,
or other debris�
2
To access the brushroll, remove
the cover from the bottom of the
floor nozzle� Shine a flashlight into
the nozzle to check for possible
blockages�
4
To reinstall the cover, line it up,
then rotate down until it clicks into
place� Use the edge of a coin to
close the three locks on the bottom
of the nozzle�
s h a r kc l e a n . c o m
16