Publicité
EN
General
This document is subject to change without
prior notification. No guarantees are given
for the accuracy of the information contained
herein. The information is in particular not to
be understood to imply warranted qualities in
any product.
Target group
This document is aimed at persons entrusted
with the installation of IT racks and rack prod-
ucts. Installation work must only be performed
by trained persons. Rittal assumes that you
possess the necessary qualifications to per-
form installation work and that you are aware
of the hazards which may arise when working
with racks and rack products.
Safety notes
Danger!
Immediate danger to life and
limb.
Unpacking and moving
7 Attention: The TS IT rack is top-heavy
and can tilt over. At least two persons are
required when moving or unpacking the
rack.
7 Failure to observe this rule may lead to seri-
ous injuries and/or material damage.
Operating environment
7 Attention: The TS IT rack is designed
exclusively for use as intended in indoor
environments.
7 Also observe the information provided by
the manufacturer(s) of the components to be
installed. Particular attention must be paid to
the permissible environmental parameters,
such as temperature and humidity, and to
the demands placed on the ambient air.
7 Attention: In case of installations with
exposed or partially exposed electrical
components located near an inflammable
surface, the TS IT rack must also be sealed
in the base with gland plates.
4
482.6 mm (19˝) level adjustments
7 Attention: Hazards due to falling devices and
equipment. If the mounting angles/mounting
frames/swing frames are to be adjusted, no
devices or equipment must be installed on
them.
7 Failure to observe this rule may lead to seri-
ous injuries and/or damage to the devices or
equipment.
Rack stabilisation
Stabilisation measures are recommended or
even imperative, depending on the place of
installation and/or the rack configuration.
Accessories:
Stabilisers/floor brackets, see Catalogue.
Earthing
7 Each TS IT rack must be properly connected
to the earthing system at the place of instal-
lation before commissioning.
7 To this end, it is recommended that the
central earthing point included in the scope
of supply is used.
7 Earth connections must only be made by
trained expert personnel holding corre-
sponding certificates of qualification.
Rack configuration
7 The installation of devices and equipment
must comply with the applicable regulations
pertaining to the installation of electrical and
data processing devices and equipment.
7 Installation work must only be performed by
trained expert personnel holding corre-
sponding certificates of qualification.
7 Determine the positions of the individual
components before starting the actual
configuration of the TS IT rack. Factors
such as weight, accessibility, power supply
requirements, temperature and air circulation
influence the order of installation and the
positioning of the individual components in
the rack. The heaviest components should
always be installed in the bottom of the TS
IT rack, as that increases the stability of the
rack.
7 At least two persons are required to install
or remove equipment or components which
weigh more than 22.5 kg.
7 Always ensure proper fixing and safe place-
ment of all components and rack elements.
7 Whether installed as a stand-alone configu-
ration or in a rack suite, TS IT racks must
always be closed with appropriate side
panels prior to commissioning.
Руководство по монтажу Rittal TS IT/Rittal TS IT Assembly and operating instructions/Notice de montage et d'emploi TS IT Rittal
Общая информа-
ция английский
Caution in case of withdrawable
components and component shelves
7 To avoid injuries or material damage, the
TS IT rack must be stabilised appropriately
before pulling out any withdrawable compo-
nents or component shelves.
7 Always pull only one component or com-
ponent shelf out at a time. The rack may
become unstable if several components are
pulled out at once.
Contact address
Rittal Service International:
Help Desk Germany:
Tel. +49 (0) 2772 505-1855
Publicité
