Checking The Display Indication - Sony Glasstron PLM-A55E Mode D'emploi

3
Follow the instructions on the screen.
1 Warning message n Follow steps 3 through 7 in "Checking the display unit
position" (pages 17 through 19).
• After carefully reading the warnings and checking the display unit position, press
the jog dial.
2 Screen alignment page n Follow steps 1 through 3 in "Checking the screen position
alignment" (pages 19 through 21).
• Read the warning carefully, and press the jog dial.
• Make sure the left and right screens are aligned, and press the jog dial.
4
Start playback on the video equipment connected to the
Glasstron.
5
Adjust the volume by turning the VOL control.
When you set AVLS in the MENU to on , you cannot turn up the volume beyond the
defined limit (see page 30).
Display unit
After you finish using the
Glasstron
Take off the Glasstron, and turn off the
power.
Note on the LCDs
The LCD screen is made with high-
precision technology. However, black
points or bright points of light (red, blue, or
green) may appear constantly on the LCD
screen. This is not malfunction.
(Effective dots: more than 99.99%)
louder
lower
VOLUME
Checking the display
indication
Press the jog dial while the picture is
displayed. The display indication appears
on the screen for five minutes.
To turn off the indication immediately,
press the jog dial again.
MEGA BASS
SURROUND
AVLS
Remaining battery life*
(page 32)
* When using the AC power adapter, the
" " mark appears on the screen.
MEGA BASS
(page 29)
SURROUND
(page 29)
AVLS
(page 30)
continued
25
-GB