Engine Wi Ll Not Start - Lea LE51260B Mode D'emploi

obstruction.
Remove the vacuum tubes and clear the debris from the blower fan housing. Remove the bag
and clear the tube. A small rod or stick may be required to clear the entire tube length.
Ensure that all debris has been cleared before reassembling the vacuum tubes.
MAINTENANCE
WARNING!
Use only original manufacture's replacement parts, accessories and attachment.
Failure to do so can cause possible injury and poor performance.
Replacing and cleaning the air filter (Fig 8)
For proper performance and long life, keep air filter clean.
1. Unclip the cover of the air filter and remove the cover.
2. Remove the air filter and clean it in warm soapy water. Let dry completely. For best
performance, replace the air filter annually.
3. Reinstall the air filter into the filter base.
4. Push the cover back in place. Push the latch back into the slot and ensure the cover is
locked in place.
Checking the spark plug (Fig 9)
1. Check the spark plug every 10-15 hours of use.
2. Remove the spark plug cover.
3. Use the spark plug wrench to remove the spark plug, by turning it counter-clockwise.
4. Clean and adjust the spark plug gap to 0.6 -0.7mm.
5. Replace any damaged or visibly worn plug with a L8RTC or equivalent spark plug.
6. Install the spark plug finger tight in the cylinder head, and then tighten it firmly with the
spark plug wrench.
Vacuum bag
Empty the bag after each use to avoid damages or obstruction that may reduce the
performances of the appliance. Clean the bag when necessary. To clean the bag, turn it's
inside out and shake. Wash the bag in soapy water. Clean the bag at least once a month.
TROUBLESHOOTING
ENGINE WI LL
CAUSE
Empty petrol tank
Primer bulb was not pressed enough
Engine flooded
Oil or improperly mixed petrol
NOT START
Fill petrol tank
Press primer bulb fully and slowly 10 times
Use starting procedure with choke lever in the position B
Drain petrol tank/add fresh petrol mixture
ACTION
25