When Connecting A Rear View Camera - Pioneer AVIC-Z3 Manuel D'installation

Section
02 Connecting the System
When connecting a rear view
camera
When this product is used with a rear view
camera, it is possible to automatically switch
from the video to rear view image when the
gear shift is moved to REVERSE (R). Rear
View mode also allows you to check what is
behind you while driving.
WARNING
USE INPUT ONLY FOR REVERSE OR MIRROR
IMAGE REAR VIEW CAMERA. OTHER USE MAY
RESULT IN INJURY OR DAMAGE.
CAUTION
! The screen image may appear reversed.
! The rear view camera function is to use this
product as an aid to keep an eye on trailers, or
backing into a tight parking spot. Do not use
this function for entertainment purposes.
! The object in rear view may appear closer or
more distant than in reality.
! Please note that the edges of the rear view
camera images may differ slightly according
to whether full screen images are displayed
when backing, and whether the images are
used for checking the rear when the vehicle is
moving forward.
CAUTION
Be sure to use only the supplied extension
lead. Use of another lead could cause fire,
smoke and/or damage this navigation sys-
tem.
18
En
Rear view
camera
RCA connector 2
Violet/white
Power cord
5 m
(16 ft. 5 in.)
The navigation unit
Extension lead (for reverse signal)
Fuse resistor
Connection method
Clamp the reversing
lamp lead.
Clamp firmly with
needle-nosed pliers.
Notes
! It is necessary to set [Camera Input] in [Sys-
tem Settings] to [On] when connecting the
rear view camera. (For details, refer to the op-
eration manual.)
! Connect to the rear view camera. Do not con-
nect to any other equipment.
To video output
RCA cable
(
sold separately)
Brown
(REAR VIEW CAMERA IN)
20 cm
(7-7/8 in.)