Connecting The Multi-Channel Processor - Pioneer AVIC-Z3 Manuel D'installation

Section
02 Connecting the System

Connecting the multi-channel processor

Note
When Pioneer multi-channel processor (sold separately) is
connected to this navigation system, make sure the "5.1 Ch
Setup" mode is activated. Please find the correct setting by
referring to the operation manual of the navigation system.
Secure the connector using the screw
supplied with multi-channel processor.
RCA
connector 1
10
En
Blue
Blue
(GUIDE SP OUT)
RCA connector 2
Black
Optical cable connection box
(supplied with multi-channel processor)
23 cm (9 in.)
The navigation unit
Light Gray
(DIGITAL OUTPUT)
Yellow/black (GUIDE ON)
When combining this navigation unit with the
multi-channel processor system, connect this
lead to yellow/black lead on the multi-channel
processor controller unit. In this way, when the
mute signal is output from this navigation
system, the audio volume is automatically
muted or attenuated.
20 cm (7-7/8 in.)
Guide speaker
(e.g. CD-TS37GP)
(sold separately)