Troubleshooting Tips - Blaupunkt 5VF4X00EME Notice D'utilisation

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 99

TROUBLESHOOTING TIPS

Before you call customer service
If you look at the diagrams on the following pages, you may save yourself a call to customer
service.
Problem
Dishwasher does not
start
Water not pumped out of
the dishwasher
Suds in the wash cabinet Incorrect detergent.
Possible causes
The fuse has blown
or the circuit breaker
has tripped.
The power supply is
not switched on.
The water pressure is
low.
The door of the
dishwasher is not
properly closed.
Twisted or pinched
drain hose.
Filter clogged.
Kitchen sink clogged. Check the kitchen sink to ensure that the water
41
What to do
Replace the fuse or reset the circuit breaker.
Remove all other appliances that share the
same circuit with the dishwasher.
Make sure that the dishwasher is switched on
and the door is securely closed.
Ensure that the power cord is properly plugged
into the wall outlet.
Check that the water supply is connected
properly and the water is switched on.
Ensure that the door is properly closed and
locked.
Check the drain hose.
Check the coarse filter.
drain is working properly. If the problem is a
non-draining sink, you may need a plumber
rather than customer service for your
dishwasher.
Only use special dishwashing detergent to
avoid the formation of suds. If this occurs,
open the dishwasher and allow the suds to
evaporate. Pour 4 litres of cold water on the
bottom of the dishwasher.
Close the door of the dishwasher and then
select any wash cycle. First the dishwasher
drains the water. Open the door when the
emptying phase is complete and check that
the suds have disappeared.
Repeat the process if necessary.

Publicité

Table des Matières
loading

Table des Matières