Using Your Appliance With The Control Panel; Overview; Use - Zehnder Deseo Verso Mode D'emploi

EN
3. USING YOUR APPLIANCE WITH THE
CONTROL PANEL

3.1 OVERVIEW

The Zehnder radiators are equipped with an advanced control system with
touch-screen controls and light indicators which indicate the set function.
Changes in settings are also remarked by an acoustic signal.
Control panel with symbols and functions:
Touch
Function
screen
T1 STAND-BY
Low-temperature heating
T2
(45°c)
Medium-temperature heating
T3
(55°c)
Maximum-temperature
T4
heating (65°c)
Maximum-temperature
T5
2-hours boost
T6 Keypad Lock
Red LED indicates radiator is
heating up
Appliance in tension
T1 T2 T3
L1 L2 L3
26
LED
L1
L2
L3
L4
L5
L6
L7
L8
T4 T5 T6
L7
L8
L4 L5 L6

3.2 USE

When connecting the power supply, all the LEDs light up for
2 seconds and you will hear a long "beep". After this, only L1 and L8
will remain on.
Touch T2 if you wish to heat up the room at low temperature. The L2
and L7 green LEDs will light up and you will hear a "beep". When the
surface of the radiator reaches the set temperature, L7 switches on
and off cyclically in order to maintain the set temperature.
Touch T3 if you wish to heat up the room at medium temperature.
The L3 and L7 green LEDs will light up and you will hear a "beep".
When the surface of the radiator reaches the set temperature, L7
switches on and off cyclically in order to maintain the set temperature.
Touch T4 if you wish to heat up the room at maximum temperature.
The L7 green LED will light up and you will hear a "beep". When the
surface of the radiator reaches the set temperature, L7 switches on
and off cyclically in order to maintain the desired temperature.
Touch the T5 button if you wish to have the maximum surface tem-
perature for a limited time (2 hours), the L5 and L7 LEDs will light up.
The radiator will operate at maximum temperature for 2 hours, after
which, it will go back to operate in the function set before the Boost
function.
If after the settings you wish to lock the keypad, press the T6 button
for 5 seconds - you will hear 4 beeps confirming the setting.
When touching the other buttons lightly, the L6 LED will flash for
2-3 seconds indicating the keypad is currently locked.
Only the T1 button will remain operational, so to put the appliance
on stand-by at any time.
To reactivate the keypad, press the T6 button for 5 seconds -
4 consecutive beeps will confirm the setting.
40019479 07/2019
EN
27