NetSpa OCTOPUS SP-OCT165 Guide D'installation Et D'utilisation page 28

4. INSTALLATION
The number of persons required for installation: 1 adult at least.
4.3. Assembling
1) Choose a flat and level location.
4) Ensure that the three connection
holes in the foam wall are aligned with
the three connection holes in the outer
liner.
7) Insert the inner liner of your spa.
2
3
9) Smooth the liner all around the spa to
ensure a good fit.
To facilitate the placement of the last
rim, press the foam structure with your
knee.
28
15 minutes for site preparation and water filling.
2) Add the foam wall segment with the
three holes in it for connection to the
base liner.
5) Add the other foam wall segments.
8) Bring the 3 connections of this liner
out of the spaces provided for this
purpose. The shortest connection is
located on the bottom left
4
1
10) Make sure that the zippers of the
inner and outer liners are aligned before
zipping them up.
3) Add the foam wall segment with the
three holes in it for connection to the
base liner.
6) Adjust the 8 segments until they form
a perfect round shape. Then, ensure
that the holes for the outer liner connec-
tion and the holes in the foam wall are
still aligned.
9) Add the 8 foam edges to each
foam and check that they are properly
adjusted.
11) Smooth the liner all around the spa
to ensure a good fit.