Noblex E-OPTICS NF 10x42 R advanced Mode D'emploi page 9

object is measured. Any partially disturbing foreground objects such as
bushes, stones and branches are ignored in this mode. If a clear target
has been targeted, the symbol "
unique to the device, i.e. if several targets are within the detection range,
the distance to the closest target is measured. The icon that is displayed
by the device in this case is " ".
BRIGHTNESS CONTROL OF THE DISPLAY
The rangefinder has a red OLED display and allows easy reading of the
results even on bright days. There are a total of six brightness levels that
can be selected. To adjust the brightness of the display, the full display mode
(V) must be activated. This mode is accessed by pressing the "M" mode
button (F) repeatedly until all three mode symbols are displayed in the top
left corner of the field of view. The current illumination level appears in the
center of the field of view (VI). To switch between the brightness levels, the
switch-on " " button must be pressed. After the appropriate brightness has
been found, the mode button can be used to return to standard mode "M"
and to continue measuring respectively to switch again to the desired mode.
UNITS OF MEASURE
With the rangefinder, you can choose between yard "Y" or meter "M" (3; 5).
To change the unit of measure of the distance display, the mode button "M"
(F) should be pressed for approx. 2 seconds.
MEASURING SEQUENCE
After the switch-on button " " (E) has been pressed, the circle of the dis-
played target mark " " (1) must be aligned with the target object.
If the switch-on button is pressed again, the distance of the object is mea-
sured and shown in the display. In the field of view, one can recognize the
activation of the laser by the symbol " " (9) appearing around the circle of
the target.
It should be noted that, for a reliable measurement, the " " button must be
pressed the second time so long until the distance value is displayed (about
2 seconds). If no value is displayed after 3 seconds, the reflection on the
object is too bad and no distance can be measured. If this is the case, the
message "END" appears in the display.
SCAN FUNCTION
Furthermore, the laser rangefinder has a scan function. If the device the
unit is moved while keeping the switch-on button " " pressed, the range
and angle measured values are constantly updated. This is possible in all
measuring modes.
16
" will be displayed. If the target is not
BATTERY WARNING
If " "appears in the lower left corner of the field of view (8),it means that
the battery power is inadequate and the rangefinder will either shut off
automatically or cannot be started properly. In this case, the battery in the
battery compartment must be replaced.
MAINTENANCE AND CARE
The laser rangefinder binoculars require no special care, it is virtually
maintenance free. Optic external surfaces must be cleaned with a fine brush
or a soft cloth if necessary. Coarse dirt particle should be rinsed off or blown
off before wiping. An excessive rubbing when brushing the optical parts can
destroy the anti-reflection coating. No chemical solvents should be used and
the device should be stored dry!
Always press only 1 button. If you do not use the device for a long time, you
should remove the battery.
Please do not dismantle and repair the device yourself, otherwise the guar-
anteed services will no longer be valid.
17