Installation Steps; Care And Cleaning - WeatherTech Ease-On Instructions D'installation

Installation Steps

NOTE: Actual application may vary slightly from illustrations.
Remove the corresponding fasteners from the rubber trim piece. This is necesary in order for the hood shield flanges to slide under the
rubber trim piece. NOTE: It may be necessary to remove additional fasteners in order to accomodate the flange, depending on size.
front edge of
hood
fastener
rubber trim
3
Insert (6) receptacles UNDER rubber trim and through
Position the hood shield with the flanges sliding between the hood
hood shield, and then into hood.
and rubber seal. Align holes.
hood shield
receptacle
rubber trim
5
4
screw
Insert (6) screws through rubber trim and into recep-
Lower hood, adjust hood bumper stops to ensure
tacles and apply pressure while tightening screw to
hood shield clears grille and headlights. Install bump
secure to hood.
ons at pre-cleaned locations on the painted hood/
fender surface.
hood shield
receptacle
rubber
trim
screw
6 7

Care and Cleaning

• Wash only with mild soap & dry with a clean cloth.
Page 2 of 2
© 2020 by MacNeil IP LLC