Krüger & Matz FLOW 7 Mode D'emploi page 27

Owner's manual
performance may be significantly reduced, charging process may
be stopped, the device may turn off or display notification about
switching off for cooling. Function available only in selected models.
Important: if the device displays notification about overheat, turn it
off and do not turn it back on until completely cooled down!
In case of overheat during charging:
1. Disconnect the charger from the device.
2. Close any running apps.
3. Wait for the device to cool down, and then begin charging the
device again.
If the part of the device where the USB port is placed overheats,
check for damage to the connected USB cable. Replace the
damaged USB cable with a new authorized cable.
The device may also overheat during operation when using several
battery consuming applications or functions. In case of overheat
during usage:
1. Close any running apps.
2. Disconnect any connectivity (Bluetooth, Wi-Fi, data transfer etc.).
3. Lower the screen brightness settings.
4. Wait for the device to cool down before attempting to use it again.
Safety precautions concerning operation environment
In order to maintain battery's longevity, and to avoid overheat,
follow basic precautions including provisions listed below:
1. Do not use / store the device in very hot or cold environments
nor expose to direct sunlight (e.g. on a car's dashboard when
using as a navigation).
2. Do not place the device on surfaces that may cause overheat
e.g. electric heating mat.
3. Do not place near sources of heat e.g. radiators, microwave
ovens, hot kitchen appliances nor high pressure containers.
4. DO NOT use damaged charger or battery!
5. Use only authorized chargers, batteries and cables! Using
27