Krüger & Matz FLOW 7 Mode D'emploi page 26

SIM CARD/MEMORY CARD INSTALLATION
• Power off the mobile phone and disconnect it from charger
before unmounting SIM cards.
• Before removing memory card, make sure it has been
disconnected first!
• Exercise caution when operating SIM card/memory card, as
friction or bending may damage the card.
• Keep the mobile phone and its fittings such as the SIM cards/
memory cards beyond children's reach.
• If the memory card cannot be read, please check whether it is has
been inserted correctly.
• Producer does not guarantee compability with every memory card.
• Please note: Dual SIM in standby will shorten the standby time
compared to single SIM.
• Make sure the battery is fully charged if it has been out of use for
a long period.
CHARGING
Charge the smartphone using the provided USB cable. Connect the
cable to micro USB port on the device. Other end of the cable plug
into provided charger or compatible USB port.
• Make sure the phone is fully charged before turning it on for
the first time.
• Use only original charging devices and batteries approved by the
producer. Using other accessories may damage the device.
Overheating
While charging, the temperature of the device and the charger
may get increased. This does not affect the device's lifespan or
performance and is in the device's normal range of operation.
However, if there is an excessive increase in temperature or
overheating, depending on the factor that caused it: device's
26
Owner's manual