Other Instructions - Safety 1st Sweet Safe Gr 0 Mode D'emploi

exposure to the sun. It is strongly recommended,
under such conditions, to cover the seat of the car
with a piece of material or something
equivalent to prevent the harness fixings, and in
particular the metal parts, from becoming hot and
burning the child.

OTHER INSTRUCTIONS:

• This child restraint is effective only if the
instructions for use are respected.
• Always fasten the child restraint even when the
child is not sitting in it.
• The user must always check that any luggage
and other objects likely to cause injury to the
occupant of the car seat in the case of impact are
properly secured.
• Never place heavy objects on the rear parcel
shelf, to avoid the danger of projectiles in the
event of an accident.
• The rigid parts and the plastic sections of a child
restraint device should be positioned and installed
in such a way that they cannot, when the vehicle is
being used under normal conditions, become
trapped under a moving seat or in the vehicle
door.
• Always check that no part of the seat or the
harness is trapped under a seat or in the vehicle
door.
• It is essential that the car seat be replaced after
an accident.
• Never modify the construction or the materials
of the car seat and the seat belt without
consulting the manufacturer.
• Do not use the child restraint device without the
cover. Do not replace the seat cover with a cover
other than that recommended by the
manufacturer, because it will have a direct effect
on the functioning of the child restraint.
• Folding seats must always be locked in place
• After purchasing, install the seat in your vehicle.
If you encounter any installation problems due to
the length of the vehicle seat belt, contact your
distributor immediately (prior to use).
• If in any doubt about the correct installation or
use of the system, the user is advised to contact
the distributor or the manufacturer of the child
restraining device system.
Care
Fabric:
• Before cleaning check the label sewn into the
fabric, you will find the wash symbols indicating
the method of washing each item.
Washing symbols :
eodmU
Shell:
• Clean the shell using a damp cloth.
25
EN