Uline H-2565 Mode D'emploi

π
H-2565
TABLE AND BENCH
MOUNTING HARDWARE
TOOLS NEEDED
Electric Drill
3/8" Socket Bit
3/8 x 4" Concrete Anchor (4)
PAGE 1 OF 3
1-800-295-5510
uline.com
MATERIALS
3/8" Standard Drill Bit (1)
BOLT KIT ASSEMBLY
1. After assembling and positioning your table or bench,
drill a hole using the standard drill bit through the
base of the table or bench in four places (two holes
on one base and two on the other). (See Figure 1)
2. Having drilled all the way through the base, you
should have a dimple mark on the concrete under
the table or bench hole. Using the concrete drill bit,
drill four holes in the concrete about 4 inches deep
or the length of the drill bit.
3. Place the table or bench over the holes and line
it up with the holes in the base. Then, drill in the
Figure 1
concrete anchors.
Para Español, vea página 2.
Pour le français, consulter la page 3.
5/16" Concrete Drill Bit (1)
0622 IH-2565