Electrical Connection - Renfert TOP spin Guide De Démarrage Rapide

Included in Delivery
1 Top spin
1 Stepped drill, size: large
1 Quick Start Guide
1 Allen key
1 Replacement threaded pin (see end of the instructions for use)
1 Laser sticker set
Installation
Unpacking
⇒ Check to ensure all delivery parts are complete (compare "Included in Delivery").
Setting Up
⇒ Place the unit on a level and stable base.
⇒ Decide which working position you require (Fig. 2).
Change laser warning label
⇒ Remove the laser warning label in your language from the sticker set and stick over the present warning
label (13, Fig. 1).

Electrical Connection

⇒ Unroll the power cable (8, Fig. 1) and insert the plug into the socket.
Operation
Switching on / off
The unit is switched on and off via the sensor surface (9, Fig. 1).
⇒ To switch the unit on, touch the sensor surface with the palm of your hand for 1 second. Do not apply
pressure.
The drilling motor is activated when the drilling table (2, Fig. 1) depressed.
Only activate the drilling motor when there is a drill in place!
Auto Off
If the unit is not used for a duration of 3 minutes, it automatically switches off.
Setting the Drilling Depth
The drilling depth can be set at the adjustable depth stop (12, Fig. 1) underneath the drilling table. If nec-
essary, carry out trial drillings.
The drilling depth changes approximately 0.1 mm for each click on the depth stop.
Drilling
⇒ Place the dental arch onto the drilling table (2, Fig. 1) and align the target laser (1, Fg. 1).
⇒ Hold the dental arch with both hands.
⇒ Press the drilling table down as far as it will go.
♦ The motor will be activated automatically and begin drilling from the bottom of the dental arch.
⇒ Guide the drilling table back up.
♦ The motor will stop when the drilling table has reached its original position.
- 3 -
en