Table des Matières
Publicité
Ontero ID
ENGLISH
Please read these instructions
before installing and using the
luminaire and keep them in a
safe place.
GENERAL INFORMATION
The luminaire is an LED lu-
minaire with a firmly attached
lamp. There are no provisions
for replacing the lamp. The lumi-
naire is wired ready for connec-
tion and complies with currently
valid standards and regulations.
The supply voltage is 220-240 V,
50/60 Hz. This luminaire com-
plies with protection class I.
The intended use is the illumi-
nation of items and objects in
permanent interior rooms. The
protection rating is IP 20. Any
other use does not count as in-
tended use. We reserve the right
to make modifications due to
technical advances. The technical
data of the valid data sheet ap-
plies in each case. Damage caused
by disregarding the instructions is
not covered by the warranty. The
luminaire is designed for an am-
bient temperature of 25°C. Tem-
peratures above 40°C can damage
the luminaire and greatly shorten
the service life.
SAFETY INFORMATION
The luminaire may only be
mounted by qualified personnel.
The local installation regulations
must be adhered to during this
procedure. The mains supply
must be disconnected before in-
stallation and maintenance work
is carried out.
The luminaire becomes warm
during use and must therefore be
installed out of arm's reach. Cool-
ing openings must remain free of
dust and must not be covered. The
safety clearance to flammable ma-
terials must be adhered to.
The luminaire contains electro-
static sensitive components. Do
not touch the illuminating sur-
face. Mains transients or voltage
peaks can damage the luminaire.
The luminaire must be protected
against damage from grid-relat-
ed overvoltage. Damage caused
by overvoltage is excluded from
the terms of the guarantee.
The affixing of stickers or other
parts not authorized by BÄRO is
forbidden. Replacement and ad-
ditional parts must be procured
from or approved by BÄRO.
Luminaires that do not work
or flicker must be disconnected
from the power supply. Do not
look directly at the light source.
In the event of malfunctions
please inform BÄRO Service
(contact information on the last
page).
Safety information for DALI
luminaires
The luminaires are fitted with
a EUTRAC 3-phase adapter.
The conductor rail's EUTRAC
data bus is subject to the safety
extra-low voltage directive. The
luminaire complies with these
requirements. When combining
with other DALI luminaires on
a conductor rail (especially with
HIT luminaires) care must be
taken that these luminaires also
comply with the SELV regula-
tions on the DALI bus.
Publicité
Table des Matières
