Mounting Options - Armacost Lighting RibbonFlex PRO+ Mode D'emploi

To direct wire, remove the AC input cable/plug and connect black live
■
wire from a branch circuit to the line side (L) of the built-in terminal
block and connect the white neutral wire to the neutral side of the
terminal block (N), as indicated on the case. This LED power supply
uses Class II AC inputs with a fully isolated case; ground wire should
not be connected.
Before restoring power, make sure all connections are tight and the
■
endcaps are reinstalled securely.
The 12-volt power cable to the tape lighting can be shortened or
■
lengthened as needed. 18AWG is recommended when lengthening
this cable; keep wire runs as short as possible. Always use suitable
wire connectors to meet installation requirements.
Use the optional screw-tabs for mounting securely when needed,
■
for example, underneath a kitchen cabinet.

MOUNTING OPTIONS

To surface mount the LED tape light under a set of cabinets in one
■
continuous run, you may need to drill a 1/2 in. hole through any
cabinet side lip that may be present. Install LED tape light through
the hole and surface mount as a continuous run.
For maximum light output and to focus light on the work surface,
■
mount the tape light 1-2 inches behind the front cabinet lip. This
mounting position works best with dull or matte fi nished countertops.
The LED tape has
a wide beam angle
To eliminate bright spots from highly refl ective countertops, mount
■
the tape light on the inside back of the cabinet lip frame facing
towards your backsplash. Because of the wide beam angle of the tape
light, this mounting position will still provide ample lighting.
Mount on inside of cabinet
lip to reduce refl ections
When mounting under a cabinet or a shelf with no lip to hide the LED
■
tape light strip, create a visual barrier using a piece of quarter round
molding or any angle trim to hide the LEDs.
Creating above cabinet uplighting
Most cabinet tops have uneven surfaces. To create indirect uplighting
■
over cabinets, simply mount the LED tape on any rigid strip (e.g.,
thin lattice or corner guard molding) and place on top of cabinets.
Angle the strip position to achieve the desired illumination.
For a seamless glow and to avoid bright light spots, move the LED
■
tape light strip further from adjacent walls.
CEILING
Mount LEDs
farther from
the wall to avoid
bright spots
OPERATION
Functions of the remote
The remote does not require line-of-sight to operate the lights. Range
■
will vary depending on your building structure and where the receiver
on the tape light is mounted.
The remote can operate up to 50 feet in optimal conditions, but each
■
installation has unique variables that may affect range.
Remote indicator
When pressing
keys, indicator
blinks if remote is
working properly.
If the indicator flashes
slowly when pressing
keys, battery power
is low and it needs
to be replaced with
a CR2032 battery.
Turns lights ON or OFF
Press & hold to turn off
Brightness settings
are saved
Incrementally adjusts
the brightness of the
lighting up or down
3