Franke FMXO 86 M Mode D'emploi Et Installation page 20

PROGRAMMER INSTRUCTIONS for Model FMXO 86 M
SYMBOLS
TIMER
KILN ACTIVE
NUMBER DECREASE
NUMBER INCREASE
AUTOMATIC
A
THIS PROGRAMMER FUNCTIONS WITH A TOUCH SYSTEM. ACT ON THE CONTROLS BY PRESSING THEM SLIGHTLY IN THE AREA
INDICATED BY THE SYMBOLS
ACTIVATION AND REGULATION OF THE TIME
Once the current s connected, the A symbol appears on the display along with the flashing numbers.
Proceed as follows to regulate the time:
Act on the symbols simultaneously for a few seconds until the numbers stop flashing. Always act on the
same symbols to regulate the time with a single impulse. Maintaining the pressure constant the numbers run
quicker. After a few seconds the time is fixed.
Any regulation of the time while an automatic program is active will cause the same to be deleted.
PROGRAMS SELECTION/ANNULMENT
The programs are set by lightly pressing or touching the previously-activated MODE symbol, holding it down
for a few seconds until a beep is heard and the symbol flashes. Herein the "at on the MODE symbol"
indication will consider its activation implicit in the way just described.
The illuminated symbol indicates that the kiln is ready for use in manual mode or is performing a program.
This will switch off every time a program ends, (except timer function) and will switch back on at every reset.
To display the sate of a program or modify the data set, act on MODE and scroll the menu verifying the data
set and modify it, if necessary.
To annul programming, act on the
MANUAL FUNCTIONING
For manual functioning, do not intervene on the programmer (the symbol be illuminated) but act using the
temperature function knobs.
The kiln is ready for normal firing without programming. The TIMER function can however be used
SEMI-AUTOMATIC FUNCTIONING (WITH FIRING TIME SET)
Touch the MODE symbol until 0:00 appears, the
acting on the symbols. After a few seconds the
Turn the functions and temperatures selector knob onto the desired values.
At the end of the set time, the acoustic signal indicates the end of firing, the symbols starts to flash and the
kiln switches off.
Turn the knobs to the off position. Touch any of the symbols to interrupt the acoustic signal and act on the
keys for a few seconds to annul programming.
SEMI-AUTOMATIC FUNCTIONING (WITH FIRING TIME END SET)
Act on the MODE symbol until END appears alternating with the current time, both flashing (the A symbol also
starts to flash). Touch the symbol to set the firing end time. After a few seconds the time re-appears and the
letter A remains fixed. Now turn the two knobs onto the desires temperature and firing time.
When the set time is reached, the acoustic signal indicates the end of firing, the letter A starts to flash and the
kiln switches off.
symbols simultaneously for a few seconds.
symbol starts to flash. Set the desired firing time by
symbol remains fixed and the current time re-appears.
20