Oven Cleaning; Oven Door; Replacing The Oven Lamp; Assistance And Original Replacement Parts - Franke FMXO 86 M Mode D'emploi Et Installation

OVEN CLEANING

CLEANING SAFETY
Switch the oven off and wait until all the heating elements are cold before touching or cleaning them.
Carefully clean the electrical appliance.
CLEANING THE SURFACE
Use a moist cloth with non-abrasive detergent, then dry with a soft rag. Only use plastic spatulas or a sponge
with vinegar and lukewarm water to remove grime from stainless steel parts.
Important: Do not use steam cleaners on any part of the oven.

OVEN DOOR:

To remove and then reattach the Oven Door, follow the instructions below.
REMOVAL / REMOUNTING THE OVEN DOOR:
Open the door completely and then insert, in both hinges, a short metal rod of roughly 3 mm in diameter,
in the holes indicated in the illustration. This blocks the hinge in the open position.
Take hold of the door with two hands at the sides, towards their lower part. Lift the door a little so that you
can slide its hinges from their 2 attachments. Now pull the door gently towards yourself, to allow the hinges
to leave their positions.
In order to remount the door, proceed with the same sequence in reverse. With the door of the oven
completely open, remove the 2 metal rods from the hinges.
After remounting, close the door slowly and make sure that it had been correctly aligned and attached.
WARNING: While the door is detached, never remove the 2 metal rods that are holding the hinges in
position.
Do not place heavy objects on the door, nor hang them from its handle: doing so could damage the product
and lead to malfunctions.
Also, do not use the oven again until you are sure that the door has been remounted correctly.

REPLACING THE OVEN LAMP

IMPORTANT: To prevent electric shocks and/or injury, read and carry out the following procedure: Before
replacing the oven lamp, make sure the power is disconnected by turning off the main switch. Make sure the
oven and lamp are cold. Then remove the lamp cover "A" by unscrewing it. Figure 6. Do not touch the hot
lamp with a damp cloth, as it may break.
Replace the lamp with another one suitable for electrical appliances of 25 W for 220 - 230 Vac. Figure 6.
If the lamp cover is damaged or broken, do not use the oven until the cover has been replaced or properly
refitted.

ASSISTANCE AND ORIGINAL REPLACEMENT PARTS

Only authorised components can be used on the electrical appliance. Do not repair or replace any oven
component not recommended in this manual. All other operations or repairs must be carried out by
authorised technical personnel.
When ordering a replacement part, specify the following data:
1) Oven model abbreviation and production number, given on the product label at the bottom front of the
oven cooking compartment.
2) Description and number of replacement part, technical information only available to the authorised
after-sales service.
3) Specify the details of the distributor that sold the oven, and the details of your nearest service centre.
17