Fastening The Front Panel; Removing The Unit - Pioneer SUPER TUNER 3D DEH-22UB Mode D'emploi

Section
03 Installation
2 Tighten two screws on each side.
Screw
Mounting bracket
! Use either truss (5 mm × 8 mm) or flush
surface (5 mm × 9 mm) screws, depending
on the bracket screw holes.

Removing the unit

1 Extend top and bottom of the trim ring
outwards to remove the trim ring. (When
reattaching the trim ring, point the side
with the groove down.)
! Releasing the front panel allows easier ac-
cess to the trim ring.
2 Insert the supplied extraction keys into
both sides of the unit until they click into
place.
3 Pull the unit out of the dashboard.
14
En
Dashboard or console
Trim ring

Fastening the front panel

If you do not plan to detach the front panel,
the front panel can be fastened with the sup-
plied screw.
Screw