Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
WARNING
Center tow bar on attachment surface, spreading side arms to at least 24", but no more than 41", and mark tow bar bracket centerlines.
1.
Using tow bar brackets as a template, drill (2) two ½" holes into attachment surface, each side.
2.
Attach tow bar brackets to attachment surface using the ½" x 1¾" Grade 5 bolts supplied with the tow bar. Note: If longer bolts are
3.
needed, use ½"-13 Grade 5 bolts.
4.
Fasten the tow bar brackets with flat washers and locknuts as shown below.
5.
Tighten these fasteners to 75 ft-lbs.
1.
Attach tow bar to tow bar brackets with (2) two wire-lock pins as shown below.
Attach tow bar coupler to 2" ball of towing vehicle.
2.
3.
Center coupler on tow bar side arms so that tow bar is symmetrical about the centerline of the vehicles.
Tighten the (4) four 3/8" nuts which attach the tow bar side arms to the coupler to 31 ft-lbs.
4.
5.
Install safety chains as described in the next section.
6.
Connect an adequate wiring harness so that stop lights, turn signals and tail lights operate on towed vehicle in conjunction with
towing vehicles lights.
7.
Read and follow warning labels on tow bar and shown below.
INSTALLATION
Mounting bolts must point in fore-aft direction. Do not mount bolts in up-down or left-right
direction.
HOOK-UP
Publicité
Table des Matières
