Safety Notes; Requirements For Gas - empasa Hexa Flame Instructions De Montage Et D'utilisation

Safety notes

Warnung
• Always make certain that the radiant gas heater is standing in a stable position. The glass tube can break if the radiant gas
heater falls over.
• Never operate the radiant gas heater if the glass tube shows evidence of cracking.

Requirements for gas

Warning
• Use propane, butane or propane-butane mixtures.
• The maximum inlet pressure of the regulator may not exceed 100 psi (6.89 bar).
• The pressure regulator and the hose assembly employed must conform to the relevant local regulations.
• Use the correct pressure regulator in accordance with the relevant local regulations and the specification on page 30 of
these operating instructions.
• Assembling must be in accordance with local regulations. In case no such regulations exist, comply with the relevant standar-
dization regulations for the storage and handling of liquefied gases.
• Dented, rusted or damaged propane gas bottles can pose a danger and must be controlled by your gas bottle supplier.
• Never use a propane gas bottle with a damaged valve connection.
• The propane gas bottle must be configured so that gas can be supplied from the gas bottle during operation.
• Never connect an unregulated propane gas bottle to the radiant gas heater.
• The rubber hose connecting the regulator with the inlet may not be longer than 50 cm.
• The rubber hose must bear a CE marking and be thermally stable from -20° to 80°.
V1/2018_EM/CZGB-S 29