Star SP312F Guide D'utilisation page 8

Fig. 2-3 Setting of the paper guide
(SP312)
Fig. 2-4 Loading the paper (SP312)
5 Set the left and right paper guides.
Leave a 0.5 mm gap between the
paper guide and the edge of the
paper and fix the lock lever.
• When you insert the stop ring that
corresponds to the groove of the
paper guide shaft shown in Fig. 2-
3, that will be the position when
you set the paper guide.
6 Turn the power switch on the printer
to the on position.
7 Cut off the front edge of the roll
paper in a straight line.
In case the front edge of the paper is
fastened with a label, etc. remove
the adhesive part of the label. If any
adhesive remains on the paper, it
will stick onto the roller of the
printer, causing the paper to misfeed.
8 Hold the roll paper as shown in the
illustration, then insert the top end
of the paper beneath the paper guide
as far as it will go and press the
"FEED" switch on the control panel
to feed the paper.
9 When the front edge of the paper
feeds out of the printer, release the
"FEED" switch. Next, insert the
rollpaper into the roll paper shaft,
and set the roll paper shaft on to the
shaft holder.
0 Insert the top edge of the paper into
the tear bar slot, then mount the rear
cover by reversing the procedure
for removing the rear cover in step
3 above.
NOTE: When the paper end mark
appears on the paper, re-
place the roll paper before
it runs out.
– 6 –