Tools And Materials; Before You Begin - Kohler K-737 Mode D'emploi

Tools and Materials

1/4"
Hex Wrench Propane
Torch

Before You Begin

IMPORTANT! Risk of product damage. Do not apply direct heat
to the valve. Excessive heat will damage the plastic components and
plaster guard.
IMPORTANT! This valve is not intended to be used as a shut-off
valve. If less than three accessories will be installed, do not plug any
outlets without completing the two-way conversion.
Observe all local plumbing and building codes.
Do not remove the plaster guard until instructed to do so.
A mixed water supply is required for this valve.
Read these instructions and plan the installation before beginning.
Component location, spacing, and situational requirements can
vary.
Shut off the water supply.
Inspect the waste and supply tubing; replace if necessary.
1205548-2-B
All manuals and user guides at all-guides.com
Tubing Cutter Thread Sealant
Plus:
• 1/2" Piping or Copper
Tubing for outlets
• 3/4" Piping or Copper
Solder
Tubing for inlets
• 1/2" NPT Plug
2 Kohler Co.