Before The First Use - Kasanova MGG000005NOC Manuel D'instruction

MILK FROTHER

BEFORE THE FIRST USE

The appliance can be used for finishing the following tasks separately: I. Warm and thick foam;
II.Warm and thin foam; III. Only warming separately, without frothing IV. Only frothing separately,
without warming.
1. Before using your milk frother, clean all the parts according to the section "CLEANING AND
MAINTENANCE".
2. Important: do not wash any parts in the dishwasher, and do not immerse the jar in water. This
may permanently damage the product and void the warranty.
3.The amount of milk to be heated or frothed shall be complied with the requirement shown in
Figure. 1.
OPERATION OF YOUR MILK FROTHER
I. Warm and thick foam
1. Place the appliance on a flat surface.
2. Then open the lid, insert the frothing paddle onto the shaft on the bottom of jar.
3. Fill the jar with the desired amount of milk, and replace the lid.
NOTE: The max milk quantity permitted to add is 150ml(see Fig. 1), to avoid milk overflowing after
frothing.The min milk quantity permitted to add is 75ml.
NOTE: Please use whole milk, frozen milk (5-10°C).
4. Connect the plug into a power outlet.
5. Press the FUNCTION button once, the working indicator of "Warm and thick foam" will light up.
Then press the ON/OFF button once,the appliance will start to work. Once the temperature of milk
has achieved the setting value, appliance will stop working;
Note: During operation, you can stop operating by pressing the ON/OFF button once.
6. When the appliance has stopped operating, open the lid, pour out the warmed and frothed milk
to enjoy it.
Caution: Minimum 3 minutes rest time must be maintained between two continuous cycles,
otherwise, the appliance will enter self-protection state automatically after working for 5 cycles
All manuals and user guides at all-guides.com
Maximun capacity for heating milk (300 ml)
Maximun capacity for frothing milk (150 ml)
Minimun capacity for heating or frothing milk (75 ml)
13