Assembly And Use - Kasanova ZSU000001 Manuel D'instructions

12 ELECTRIC ICE SHAVER

ASSEMBLY AND USE

1. Always ensure that the appliance is switched off and that it is not plugged
into an electrical outlet before you assemble or dismantle the ice shaver.
2. Refer to Fig. A and Fig. B for an assembly diagram, parts reference and
operational diagram.
3. Place the machine base/stand (Fig. A, K) on a flat sturdy counter or table.
4. Insert the drive gear (Fig. A, H) into the base.
5. Align and insert the exterior bowl (Fig. A, E2) in drive gear.
6. Align and insert the gear hoop (Fig. A, D) in the exterior bowl.
7. Align and insert the interior bowl (Fig. A, C) in the exterior bowl. You may
have to slowly spin the interior bowl to ensure that it fits correctly.
8. Secure the interior bowl to the exterior bowl using the securing nut (Fig. A,
B). Insert the nut in the center of the interior bowl and turn clockwise.
9. Place an empty bowl (not supplied) on the base of the unit just below the
exterior bowl (Fig. B. 1.). This bowl will be used to collect the shaved ice.
10. Place fully frozen household ice cubes inside the interior bowl (Fig. B. 1.).
Fill the bowl level with ice cubes. Most ice made from residential ice ma-
kers will work. Some commercially bagged ice may work as well. However,
if your ice it too hard and has been in the freezer too long, you may need
to allow the ice cubes to temper or thaw for a few minutes before shaving.
Allowing the ice to temper, the machine will produce a fluffier snow, which is
a common practice with commercial ice shavers as well.
11. Place clear lid (Fig. A, A) on top of the interior bowl while lining up the lid's
flange.
12. To shave ice, turn the lid counter clockwise (Fig. B. 2.) until the flange acti-
vates the safety switch (Fig. A, G).
13. To stop shaving ice, turn the lid clockwise (Fig. B. 3.) to deactivate the safety
switch.
14. Unplug the ice shaver from the power supply after each use.
15. Add premium syrup from SUNCONShavedIce.com (Fig. B. 4.) to the shaved
ice and enjoy!
CLEANING
• Dismantle the appliance in reverse order of the procedure described for
assembly.
• While cleaning, use caution and pay special attention to the ice shaver bla-
de. Avoid all contact with the blade to prevent injury to yourself or others.
• Avoid using abrasive detergents or cloths.
• The motor unit may be cleaned with a slightly damp cloth but do not soak or
immerse the motor unit in water or other liquid.
• All the machine parts other than the motor assembly (Fig. A) may be wa-
All manuals and user guides at all-guides.com