Digi Connect WS Mode D'emploi page 37

Connect WS administrative settings
Hypertext Transfer Protocol (HTTP)
Hypertext Transfer Protocol over Secure Socket Layer (HTTPS)
This device provides web pages for configuration that can be secured by requiring a user login.
Advanced Digi Discovery Protocol (ADDP)
The Advanced Digi Discovery Protocol (ADDP) runs on any operating system capable of sending multicast IP packets
on a network. ADDP allows the system to identify all ADDP-enabled Digi devices attached to a network by sending out
a multicast packet. The devices respond to the multicast packet and identifies themselves to the client sending the
multicast. ADDP communicates with the TCP/IP stack using UDP. The TCP/IP stack should be able to receive
multicast packets and transmit datagrams on a network.
Access to ADDP service can be enabled or disabled, but the network port number for ADDP cannot be changed from
its default.
Simple Network Management Protocol (SNMP)
Simple Network Management Protocol (SNMP) is a protocol for managing and monitoring network devices. SNMP
architecture enables a network administrator to manage nodes-servers, workstations, routers, switches, hubs on an
IP network, manage network performance, find and solve network problems, and plan for network growth.
Connect WS administrative settings
This section discusses the administration tasks that need to be performed on your Connect WS device periodically,
such as file management, changing the password used for logging onto the device, backing up and restoring device
configurations, updating firmware and Boot/POST code, restoring the device configuration to factory defaults, and
rebooting the device.
Backup/restore
Once your Connect WS device is configured, it is good practice to back up your configuration settings in case
problems occur later, firmware is upgraded, or hardware is added. If you need to configure multiple devices, you can
use the backup/restore feature. Back up the first device's configuration settings to a file, then load the file onto the
other devices.
Firmware update
You can update the firmware code for the Connect WS from a file on a PC. The recommended method is to download
the firmware to a local hard drive.
Reboot
Changes to some device settings require saving the changes and rebooting the Digi device. To reboot the device:
1 From the web interface menu, select Administration > Reboot.
2 On the Reboot page, click the Reboot button. Wait approximately 1 minute for the reboot to complete.
Connect WS Hardware Reference Manual 37