Speed Adjusting Dial; Indication Lamp - Makita XRU04 Manuel D'instruction

1
3
B
A
2
014159
This trimmer has a reversing switch which is only
provided to change the direction of rotation so that it can
be used to remove weeds and debris entangled in the
trimmer. To operate the tool normally the "A" side of the
switch should be depressed.
To remove weeds and debris that are jammed in the
rotating head the tool can be reversed by depressing
the "B" side of the switch. In the reverse position the
tool will only operate for a short period of time and
automatically shut off.
NOTICE:
Always check the direction of rotation before
•
operation.
Use the reversing switch only after the trimmer
•
comes to a complete stop. Changing the direction
of rotation before the trimmer stops may damage
the tool.

Speed adjusting dial

1
013922
The trimmer speed can be infinitely adjusted from 3,500
-1
to 6,000 min with the speed adjusting dial.
Turn the speed adjusting dial clockwise for higher speed,
and counterclockwise for lower speed.
1. Reversing switch
2. A position
depressed for
normal operation
3. B position
depressed for
weed and debris
removal
1. Speed adjusting
dial
-1
Battery protection system
(Lithium-ion battery with star marking)
1
012128
Lithium-ion batteries with a star marking are equipped
with a protection system. This system automatically cuts
off power to the tool to extend battery life.
The tool will automatically stop during operation if the
tool and/or battery are placed under one of the following
conditions:
Overloaded:
•
The tool is operated in a manner that causes
it to draw an abnormally high current.
In this situation, release the switch trigger on
the tool and stop the application that caused
the tool to become overloaded. Then pull the
switch trigger again to restart.
If the tool does not start, the battery is
overheated. In this situation, let the battery
cool before pulling the switch trigger again.
Low battery voltage:
•
The remaining battery capacity is too low
and the tool will not operate. In this situation,
remove and recharge the battery.
Indication lamps
1
2
013836
When the protection system works during the operation,
the lamps light up.
Refer to the following table for the status and action to
be taken for the indication lamp.
8
1. Star marking
1. Battery indicator
2. Power indicator