Using Your Appliance; Energy Saving - Di4 Jet Pressing Xtream Compact 8b Mode D'emploi

EN
Do not allow the power cable to come into contact with the soleplate when it is hot.
B&B TRENDS S.L. disclaims all liability for damages that may occur to people, animals or objects, for
the non-observance of these warnings.

USING YOUR APPLIANCE

Filling the water tank
This appliance has been designed to use normal tap water.
IMPORTANT: Do not additive! Do not use additives! The addition of other liquids, such as perfume,
vinegar, starch, condensation from tumble dryers or air conditioning systems, or chemicals will damage
the appliance. Any damage caused by the use of the aforementioned products will he guarantee void!
Fill the water tank (7). Never fill beyond the level "max" (8)
Tip: To prolong the optimum steam function, you may mix tap water with distilled or demineralised water
1:1. If the tap water in your area is very hard, mix tap water with distilled or demineralised water 1:2.
Heating
1. Unwind the supply hose (4) and the mains cable (5). Plug mains cable into an earthed socket.
2. Press the button (2) to switch the appliance on. The indicator light (2) will flash indicating that the
appliance is heating up.
3. When the iron is ready to use, the indicator light (2) will remain permanently lit. Two beeps will be
heard.
Ironing
1. Press the steam release button (12) for ironing with steam.
IMPORTANT:
During first use: Press the steam release button for 40 seconds until steam comes out.
During the first seconds of use the amount of steam will be lower and it will increase progressively.
Drops of water may leak out while there is still air in the circuit.
WARNING: Ironing with an excessive amount of steam may produce condensation of the hot
water and dripping from the ironing board or through any other permeable surface.
"Steam Turbo Shot" function
This appliance has a special function for tackling difficult creases.
1. Press the steam release button (12) two times in quick succession (double-click). Powerful shots
of steam will be released.
Vertical steam
Can be used to remove creases from hanging clothes, curtains, etc.
2. Hold the iron in an upright position 15 cm away from the garment to be steamed.
3. Press the steam release button (13) repeatedly with pauses of at least 5 seconds.
WARNING: Never point the steam jet at garments being worn, or at people or animals.

Energy saving

If the energy saving setting is selected, you can save energy and water and still achieve good results
when ironing most of your garments.
1. Press the energy saving button "ECO/BOOST" (3). The indicator light will come on.
2. To switch back to the normal energy setting, press the "ECO/BOOST" button again. It is advisable to
use the normal energy setting to get optimum results on thick and very wrinkled fabrics.
19