Operating Your Wine Cooler - Teka RVI 30097 GBK Mode D'emploi

 The controls of your Wine cooler (the upper zone and middle zone)
1) " " button
To control this unit's power,ON/OFF.(press and hold this button for approximately 3
seconds).
2) " " button
To set the temperature of the upper chamber.
(Press once the button, the temperature will increase 1°C)
3) " " button
To set the temperature of the middle chamber.
(Press once the button, the temperature will decrease 1°C)
4) LED display window
Display temperature for upper zone.
5) LED display window
Display temperature for middle zone.
6) " " button
To control the inner light turn on/off .
(If you press this button, the inner light is not controlled by the reed switch, and keep
lighting.)
7) indicator light
Compressor in operation display.
 Setting the Temperature Control
Each cooling compartment of the wine cooler (upper & middle) is independently controlled.
To set the temperature:
Connect the power cord to a properly grounded outlet. In the event of a power interruption.

When pressing
upper or middle compartment automatically. The LED will flashing and display the setting
temperature.
Press once the button, the temperature will decrease or increase 1°C. After stopping
pressing the button for 5 seconds, LED figure will stop flash, then exit setting model.
Upper compartment::The temperature setting can be adjusted from 5°C to18 °C.
Middle compartment: The temperature setting can be adjusted from 5°C to 10°C.

OPERATING YOUR WINE COOLER

or button, the system will be entering the set up mode in the
32