Teka RVI 30097 GBK Mode D'emploi page 33

 Before Using Your Wine cooler

Remove the exterior and interior packing.

Before connecting the Wine cooler to the power source, let it stand upright for
approximately 2 hours. This will reduce the possibility of a malfunction in the cooling
system from handling during transportation.

Clean the interior surface with lukewarm water using a soft cloth.

This appliance is intended to be used in household and similar applications such as
– staff kitchen areas in shops, offices and other working environments;
– farm houses and by clients in hotels, motels and other residential type
environments;
– bed and breakfast type environments;
– catering and similar non-retail applications.

When disposing your appliance, please choose an authorized disposal site.
 Installation of Your Wine Cooler

This appliance is designed to be for built-in (fully recessed) (Refer to sticker location
the back of this appliance).

This appliance is intended to be used exclusively for the storage of wine.

Place your Wine cooler on a floor that is strong enough to support it when it is fully
loaded. To level your Wine cooler, adjust the front leveling leg at the bottom of the
Wine cooler.

This appliance is using flammability refrigerant. So never damage the cooling pipe
work during the transportation. Locate the Wine cooler away from direct sunlight and
sources of heat (stove, heater, radiator, etc.). Direct sunlight may affect the acrylic
coating and heat sources may increase electrical consumption. Extreme cold
ambient temperatures may also cause the unit not to perform properly.

Avoid locating the unit in moist areas.

Plug the Wine cooler into an exclusive, properly installed-grounded wall outlet. Do
not under any circumstances cut or remove the third (ground) prong from the power
cord. Any questions concerning power and/or grounding should be directed toward a
certified electrician or an authorized Products service center.
 Attention

Store wine in sealed bottles;

Do not overload the cabinet;

Do not open the door unless necessary;

Do not cover shelves with aluminum foil or any other shelf material which may
prevent air circulation;

Should the Wine cooler be stored without use for long periods it is suggested, after a
careful cleaning, to leave the door ajar to allow air to circulate inside the cabinet in
order to avoid possible formations of condensation, mold or odors.
 Ambient Room Temperature Limits
This appliance is designed to operate in ambient temperatures specified by its temperature
class marked on the rating plate.
Class
Extended Temperate
Temperate
Subtropical
Tropical
NSTALLATION INSTRUCTIONS
Symbol
SN
N
ST
T
31
Ambient Temperatures range(℃)
﹢10 to﹢32
﹢16 to﹢32
﹢16 to﹢38
﹢16 to﹢43