Using The Blender - Inventum NB230RS Mode D'emploi

4

using the blender

ASSEMBLY
Fig. 1
Before plugging into a socket, check that the voltage in your home corresponds with the voltage printed on the bottom of the
appliance. Place the blender on a flat, clean and dry surface.
1. Insert the plug into a power supply socket.
2. Put all the ingredients in a jug. Note: do not overfill! To avoid spilling, do not add ingredients past the maximum - MAX - fill line.
3. Place the blade assembly onto the jug and twist it on tightly until you have a good seal - figure 1.
Caution: the knives are very sharp.
4. Turn the jug upside down and place it onto the base, aligning the tabs on the jug with the base. Push the jug down and turn it
clockwise, until you feel it click into place - figure 2.
Note: the appliance will not function if the jug is not assembled onto the base properly.
5. Press one of the buttons to activate the blender - figure 3.
6. Ensure the motor has stopped running before removing the jug. Turn the jug counter clockwise - figure 4 - and pull it straight up to
remove - figure 5.
7. Turn the jug upright and remove the blade assembly by twisting the blade assembly counter clockwise. Be sure to store the blade
assembly attached to an empty jug when not in use.
8. Twist the lid with the drinking spout onto the jug to enjoy your drink on the go. Press the flip top cap firmly into the opening to get
the best seal. Ready to go!
9. Make sure the base is unplugged when not in use.
START / STOP
Press the start stop button to activate the blender. Press the start stop button again to stop the blender.
The blender will stop automatically after 60 seconds when it has not been stopped yet.
AUTO BLEND
When using the button auto blend the blender pulses, blends and stops alternately. When using this function with fresh and softer
ingredients, you will get a soft and smoother result without having to shake the jug. Do you find the consistency of your drink is okay
then switch off the blender by pressing the button auto blend again.
Operation mode: blend for 3 seconds, stop for 2 seconds. In total 10 cycles before the blender stops automatically.
PULSE
The blender will blend as long as you hold down the pulse button. When releasing the button, the blender stops.
push
Fig. 2
START
AUTO BLEND
STOP
USE
Fig. 3 Fig. 4
REMOVE
Fig. 5
English
11
•