Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
PARTS & ASSEMBLY
Indicator Light
HOW TO OPERATE
Before first use, place the hot plate on a flat, sturdy and heat-resistant surface.
NOTE: It is also recommended to turn the hot plate on the highest heat
setting and heat up for several minutes. This will burn off any residue left from
manufacture. Some odor and smoke could develop during this process, ensure
good ventilation and it should disappear after few minutes of use.
1.
Place the unit on a clean, dry and level surface near an electrical outlet. Allow
about eight inches of clear space all around the exterior of the unit.
2.
Make sure temperature control knob is set to the "OFF" position.
3.
Plug into a wall outlet.
4.
For most efficient operation, select a pot or pan that has a bottom diameter that fits the 4-inch
heating plate. NOTE: When trying to boil water or wanting to get maximum heat, it's best if using a
thin pot or pan for better transfer of heat. It's also recommended to use a lid to keep the heat inside.
CAUTION: Do NOT place thick-walled glassware, plastic containers,
soft-glass bottles, or jars on the hot plate.
5.
Place the pot or pan onto the hot plate and use the temperature
guide to cook as instructed by your recipe.
NOTE: The hot plate will automatically turn on and off (light turns on and off )
when the temperature reaches maximum temperature so it doesn't overheat and
melt internal components. This will not affect cooking temperature or time
6.
After cooking is finished, turn the temperature control knob to the "OFF" position.
5
Temperature
Dial
Heating Surface
Non-skid feet
Publicité
Table des Matières
