Installation Instructions; Window Slider Kit Installation - Danby Premiere DPA110DHA1CP Guide D'utilisation Et D'entretien

Installation Instructions

LOCATION
WINDOW SLIDER KIT
INSTALLATION
Air condtioning mode ONLY
Your window kit has been designed to fi t most standard "vertical" / "horizontal" windows up to a maximum height of 80"
(203cm). For vertical window applications, multi lock positions are provided on the edge of each slider section to secure
each sliding section together.
1. Select a suitable location, making sure you have access to an electrical outlet.
2. Install the fl exible hose to the rear side of the unit. Insert the hose collar on top of the exhaust opening and twist to
lock into position.
3. Install the adjustable window slider kit as required (see Fig. 3a and 3b).
4. Install the opposite end of the fl exible exhaust hose into the window exhaust adapter.
5. Install the window exhaust adapter into opening in the slider section, making sure the window slider sections are
secure.
6. Plug the unit into a 115V/60Hz grounded electrical outlet.
• The air conditioner should be placed on a fi rm foundation to minimize noise
and vibration. For safe and secure positioning, place the unit on a smooth, level
fl oor strong enough to support the unit.
• The unit has casters to aid placement, but it should only be rolled on smooth,
fl at surfaces. Use caution when rolling on carpeted surfaces. Use caution and
protect fl oors when rolling over wood fl oors. Do not attempt to roll the unit over
objects.
• The unit must be placed within reach of a properly rated grounded socket.
• Never place any obstacles around the air inlet or outlet of the unit.
• Allow at least 30 cm of space away from the wall for effi cient air conditioning.
Your window slider kit has been designed to fi t most standard vertical and hori-
zontal window applications, however, it may be necessary for you to modify some
aspects of the installation procedures for certain types of windows.
NOTE: If the window opening is less than the mentioned minimum length of the
window slider kit, cut the end without the hole in it short enough to fi t in the window
opening. Never cut out the hole in window slider kit (visit www.danby.com for
general instruction videos).
6