Kenwood KVT-617DVD Manuel D'installation page 4

Connection
For the sake of safety, be sure to
connect the parking sensor.
Connect to the vehicle's parking brake detection
switch harness using the supplied relay connector.
Ignition key switch
Car fuse box
Car fuse box
(Main fuse)
C
+
Battery
Antenna cord
Connect to the terminal that is grounded when either the
To connect the kenwood navigation system,
consult your navigation manual.
Depending on what antenna you are using, connect either to the
control terminal of the motor antenna, or to the power terminal for
the booster amplifier of the film-type antenna.
When using the optional power amplifier, connect to its power
To "EXT.AMP.CONT. " terminal of the amplifier having the external
4
|
English
To vehicle's reverse lamp harness
To car light control switch
To Steering remote
A
ACC
A
B
B
C
Accessory 4
FM/AM antenna input
telephone rings or during conversation.
control terminal.
amp control function.
Do not connect.
Parking sensor wire (Green)
Reverse sensor wire (Pink)
Dimmer control wire (Orange/White)
Steering remote control input
(Light Blue/Yellow)
Ignition wire (Red)
Battery wire (Yellow)
Ground wire (Black) - (To car chassis)
AV INPUT 2
L
VIDEO
FM /AM ANTENNA AV INPUT 1
L
VIDEO
Ground wire (Black) - (To car chassis)
C
Battery wire (Yellow)
B
Mute wire (Brown)
Motor antenna control wire (Blue)
Power control wire (Blue/White)
External amplifier control wire (Pink/Black)
PRK SW
REVERSE
ILLUMI
REMO.CONT
ACC
(5A)
BATT
Receiver unit (front side)
PRE OUTPUT
SUB
AV OUTPUT
REAR FRONT
R L L L L
R-CAM V-IN
VIDEO
R R R R R
Accessory 1
(10A)
MUTE
ANT CONT
P. CONT
EXT.CONT
Monitor unit
Accessory 3
POWER