Light-N-Carry LENEXA LNC7250 Manuel De L'opérateur page 6

OPERATING INSTRUCTIONS
Do not turn on the action light while it is being charged.
Direct the lens away from your eyes before turning on the action light.
Press the POWER button to achieve the operational mode desired:
- Press POWER once for Spot Light Mode.
- Press POWER twice for Flood Light Mode.
- Press POWER three times for Dual Mode.
- Press POWER a fourth time to turn the unit off.
NOTE: When the light is in any working mode, press POWER to turn it off.
NOTE: When the light is in a working mode and you turn power off, it will
resume in the same mode when turned back on. To clear the working
mode, quickly turn the unit off and on a second time.
Dimming Feature
To adjust the intensity of the light output in any working mode, press and
hold down the POWER button. After a 2-second hesitation, the unit will be-
gin to dim to its lowest setting, blink, and then begin to brighten again. To
set the unit at a specific level of intensity, release the power button when
the desired intensity is reached.
Hands Free Mode
To enter Hands Free mode, while the light is on, press the Hands Free
button. The unit will turn off and the charging status LED will light red to
indicate that the unit is in hands free mode. Wave you hands across the
face of the light (within 4 inches) to turn it on or off.
Recharge the action light after use, and every 3 months when not is use.
LNC7250 Accessories
Your action light comes equipped with 3 accessories to enable you to
deploy the light in a variety of ways to best meet your application needs.
6