TEMPUR-PEDIC ACTIVEbreeze ERGO EXTEND Manuel Du Propriétaire page 14

remote control
FAN MODES
Standard Fan Operation
Fan buttons will operate the fan(s) at the selected
speed for up to 10 hours. Simply tap the LEFT or
RIGHT Fan buttons to cycle through the levels of
intensity. The LEFT and RIGHT side of the bed are
identified below. For fan operation in a dual/sync
setup, please refer to Tandem Mode.
Right Side Left Side
•
•
•
Fan Sync Mode
Pressing the SYNC button will simultaneously cycle
the left and right fans through the fan speeds (Low/
Medium/High/Off).
Step-Down Mode
This mode will operate the fan at the selected speed
selection for 5 hours, and then "step-down" to a
lower speed for an additional 5 hours.
To access this mode, once the desired speed has
been selected, press and hold the corresponding fan
button for 3 seconds. The selected fan speed LED
will blink twice (2x) to indicate that the "step-down"
mode is activated.
•
•
•
12
All manuals and user guides at all-guides.com
1 = Low
2 = Medium
3 = High
*There is 1 fan in a TXL or CSK base. Any one of
the 3 fan buttons will control the single fan.
Low (for 5 hours) → Off
Medium (for 5 hours) → Low (for 5 hours)
High (for 5 hours) → Medium (for 5 hours)
Tandem Mode
This mode applies to a sync setup of TXL and
CKS sizes only. When activated, the fan on the
base assigned "left side" will be controlled by
the LEFT fan button, and the fan on the base
assigned the "right side" will be controlled by the
right fan button. Please note, all other remote
functions will control both bases simultaneously.
To activate this mode, press and hold the LEFT
Fan and SYNC button at the same time on the
remote control paired to the left side base.
Left Side
Right Side Backlight LED flash (2x) after 6 seconds indicates
that Tandem Setup is on.
To Deactivate Tandem Mode and revert the
system to normal setup, press and hold the RIGHT
Fan and SYNC button at the same time. Backlight
LED flash (2x) after 6 seconds indicates that
Tandem Setup is off.
Retail Demo Mode
Press and hold the LEFT and RIGHT buttons
simultaneously for 3 seconds, after which
backlighgt LED will flash 2x. The fans will
operate at maximum intensity, and then shutoff
automatically after 5 minutes.
To deactivate Retail Demo mode, press any one
of the 3 fan control buttons to turn retail demo
mode off.