Installation And Start-Up - Abus COWM510 Manuel D'utilisation

Installation and start-up

Installation and start-up
The following two variants are possible for operating the CO alarm:
Wall installation
Take the following steps in the specified order to install the alarm on the wall:
1.
2.
Make sure not to damage any cables!
Keep CO alarm away from getting plaster dust when you drill the holes!
3.
Desk-stand
"At breathing level" in bedrooms and living rooms without combustion devices
during operation.
1. Use the two feet to place the alarm on the bottom side of the housing on a flat,
dust-free base.
80 mm
5 mm
Use a water level to mark the drill
holes in the horizontal position
(Spacing 80 mm).
Drill the holes with a suitable
Ø
power drill at the previously
marked locations. (Ø 5 mm)
Press the plastic dowels into the
drill holes and screw in the two
supplied screws until the screw
heads stick out approx. 5 mm.
– 32 –