Kimpex Yamaha Viking 374780 Instructions D'assemblage page 7

"CLICK N GO 2" PLOW ATTACHMENT
Yamaha Viking Yamaha Viking
Yamaha Viking Yamaha Viking
7) Install the pre-assembly of the attachment plate
and the four (4) spacers
square bend U-bolts
and the two (2) M6-1.0 x 35 mm hex. bolts
Secure with eight (8) M8-1.25 hex. nuts
two (2) M6-1.0 nuts
04
See Figure 7.
Fig. 7
8) Assemble four (4) M8-1.25 x 25 mm carriage bolts
and one (1) M8-1.25 x 20 mm hex. bolt
plate using five (5) M8-1.25 hex. nuts
A
first threads only, except on the hex. bolt
must be fully tightened. See Figure 8.
E
C
A
C
Fig. 8
KIMPEX INC. / 5355, rue St-Roch / Drummondville (Québec) Canada / J2B 6V4
KIMPEX USA / 100 Walnut Street / Champlain, New York / 12919
28105 5 5 5 28 2810 28 • A A A A - - - - 2810 28105 5 5 5 28 28 • Printed in Canada
2810 2810 28 28 2810 2810 28 28
ASSEMBLY INSTRUCTIONS
with the 92.9 mm
02
installed in the previous step
B
.
03
and the
D
, then tighten the assembly.
on the V-
E
. Screw the
D
, which
E
9) Assemble the V-plate
01
by first aligning the rear carriage bolts, then the
front carriage bolts. See Figure 9.
Fig. 9
10) Once the M8-1.25 x 25 mm carriage bolts
inserted to the bottom of the oblong holes of the
attachment plate
Position of the Push Frame Hook Assembly
C
Install the push frame hook assembly in Position 3. Refer
to the instructions of the push frame for the assembly
procedure.
374780
KIMPEX NO.
on the attachment plate
A
C
, tighten all bolts in place.
01
01
are
3