Kimpex Yamaha Viking 374780 Instructions D'assemblage page 6

"CLICK N GO 2" PLOW ATTACHMENT
Yamaha Viking Yamaha Viking
Yamaha Viking Yamaha Viking
Plow Attachment Installation Procedure
1) Pass the two (2) M6-1.0 x 35 mm hex. bolts
frame of the vehicle as shown in Figure 1.
03
Fig. 1
2) Install the attachment plate
only using the two (2) bolts
previous step and the two (2) M6-1.0 nuts
step is used only to drill holes in the skid plate of the
vehicle before full installation). See Figure 2.
Fig. 2
3) Using the plate as a reference, drill with the tool
provided at the locations identified in Figures 3
and 4.
Fig. 3
KIMPEX INC. / 5355, rue St-Roch / Drummondville (Québec) Canada / J2B 6V4
KIMPEX USA / 100 Walnut Street / Champlain, New York / 12919
2810 28105 5 5 5 28 28 • A A A A - - - - 2810 28105 5 5 5 28 28 • Printed in Canada
2810 2810 28 28 2810 2810 28 28
ASSEMBLY INSTRUCTIONS
in the
03
03
under the vehicle
01
installed in the
03
(this
04
Fig. 4
4) Remove the attachment plate
5) Pre-assemble the four (4) spacers
M8-1.25 x 25 mm carriage bolts
1.25 hex. nuts . Tighten the first threads only. See
D
Figure 5.
C
02
01
D
Fig. 5
6) Pass the four (4) square bend U-bolts 92.9 mm
the vehicle frame in the previously drilled holes.
Remove the bolts from the skid plate if necessary.
See Figure 6.
Fig. 6
374780
KIMPEX NO.
.
01
using four (4)
02
and four (4) M8
C
in
B
2