Optika Italy B-1000 Serie Manuel D'instructions page 13

5. Insert the condenser under the stage: position
until it is well inserted into its holder (under the
condenser there is a pin that must fully enter the
holder guide). (Fig. 5)
6. Lock the condenser fixing knob ①.
7. Mount the stage: lower the support using the co-
arse focus knob, then place the stage and firmly
tighten the lock screw ②. (Fig. 6)
8. Screw each objective into the thread of the no-
sepiece, clockwise with increasing magnification.
(Fig. 7)
9. Insert the power supply jack in the socket placed
in the rear side of the of the microscope. (Fig. 8)
②
Page 13
①
Fig. 5
Fig. 6
Fig. 7
Fig. 8