Electrical Data - Field Controls ELIMINATOR EL-1 Mode D'emploi

ELECTRICAL DATA

VOLTS
120 VAC
A permanent wiring method must be used for power connection. It is recommended that a minimum size of
14 AWG wire for electrical supply connections and wiring should be suitable for 60
The ELIMINATOR™ should be wired with an over current protection device (fuse or circuit breaker) rated 15
amperes or less. Wiring method should be in accordance with the National Electrical Code and any local
code requirements.
WIRING (See Figures 5 & 6)
AMPS HZ WATTS
.60 60 35 3000
page 3
RPM THERMAL OR IMPEDANCE PROTECTION
YES
C (180 F) temperature.
O O
Figure 5
Figure 6