Nestle Health Science Compat ella Mode D'emploi page 46

EN
48
4
2"
5
6
7
8
9
• Hold 2 seconds (2") to activate auto-prime. The pump will fill the administration set
Prime the administration with a predetermined volume.
set • P ress again to stop priming at any time.
Note:
Press
feed delivery.
Set the rate
• R ate may be set from 1-600 mL/hr in 1 mL/hr increments.
Note:
Press
volume or the amount of tube feed to be given multiple times.
Set the bolus volume
• B olus may be set from 1-2000 mL in 1 mL increments
Note:
Press
from the start of one bolus to the start of the next bolus.
• I nterval may be set from 00:15-12:00 hr in-15 minute increments.
Set the interval
• The minimum interval possible is automatically calculated and shown, based on rate
and bolus values from steps 5 and 6.
Note:
Press
total amount of tube feed to be given if desired.
• Feeding with a Dose Limit:
6 to 4000 mL in 1 mL increments. The pump will run multiple bolus until the Total
Set the total volume
Volume limit has been reached.
• Feeding without Dose Limit:
run multiple bolus until the nutrition container is empty.
Note:
Ensure nutritional therapy settings correspond to the nutritional therapy prescribed.
Connect the administration set to the patient's feeding tube.
Start the Nutritional
Press
Therapy
therapy and display the progress.
Do not prime when connected to the patient's feeding tube.
to access the screen and use
SET RATE
Press to reset value.
to scroll the screen and use
SET BOLUS
Press to reset value.
to scroll the
SET INTERVAL
Press to reset value.
to scroll the
SET TOT VOLUME
The value may be set from 1 bolus programmed in step
Set the value to CONT (CONTINUOUS), the pump will
Press to reset value.
to run the nutritional therapy. The pump will automatically run the nutritional
and to define the rate of tube
and to define the bolus
screen and use and to define the time
screen and use and to define the