TASSILI TANGO-3 Guide D'installation page 11

FLUSH BUTTONS ON TANK
Pressing both buttons at once will activate the partial flush amount (0.9 gal / flush or 3.4 L / flush). The partial flush button (with 3 dots)
should line up over the blue actuator on the flush tower in the tank. The full flush button (with 9 dots) should line up over the white
actuator on the flush tower in the tank.
PARTIAL FLUSH BUTTON
(WITH 3 DOTS) FOR LIQUID WASTE.
1 GAL / FLUSH
3,8 L/FLUSH
TIPS :
If the flush function does not work properly, remove the tank lid
and push the button directly into the tank. If the flush function
works you will need to adjust the push button mounted on the tank
lid by following these specifications:
1. Turn the lid upside down.
2. Loosen the black self-locking nut.
3. Adjust the white thread rod by making one full turn
counterclockwise.
4. Retighten the black self-locking nut.
5. Put the lid pack on the tank and test the flush. If it is still not
flushing properly, repeat steps 1 to 4 until the problem is
resolved.
6. If you find that one counterclockwise turn is excessive and
causes the flush valve to stay open, adjust ½ turn clockwise
and return to step 4.
NETTOYAGE ET ENTRETIEN
To clean the toilet, use warm, soapy water; rinse thoroughly with fresh water and dry with a soft cloth. Avoid detergents,
disinfectants, or cleaning products in aerosol cans. NEVER use abrasive powders scouring powders or pads on the toilet seat.
Some bathroom chemicals and cosmetics may damage the seat's finish.
!
WARNING: Do not use in-tank cleaners. Products containing chlorine (calcium hypochlorite) can seriously damage fittings in the
tank. This can cause leakage and property damage.
Turn on the water supply. Submerge the FLOATER under water for 30 seconds. Adjust the water level
by turning the WATER LEVEL ADJUSTMENT ROD and moving the FLOATER up and down.
FULL FLUSH BUTTON
(AVEC NEUF POINTS) FOR SOLID WASTE.
1,6 GAL / FLUSH
6 L/FLUSH
BLACK PLASTIC
LOCK NUT
BLUE
THREAD
ROD
- 5 -
BLACK PLASTIC LOCK
NUT
WHITE
THREAD ROD