b4Adventure slackers SLACKLINE Mode D'emploi page 3

WARNING:
The tension on the lever of the ratchet must not exceed the safety limit of 400N of force.
WARNING: The Slackline can be tensioned only by hand. Never tighten the slackline between two
cars or other means since pre-tension can rise unexpectedly. After the tensioning process, the
ratchet must audibly click into the end position.
Step 5: Copy the same steps for the teaching line. Teaching line should be set up approximately 1.50-2m above
the Slackline. The height depends on the size of the user who is holding on to the top and trying to keep
his balance
Release the Ratchets:
1) To release the ratchet, pull up the vinyl coated gate inside the ratchet
handle and open all the way until flat.
EXPECT A "POP" sound.
2) The second release lever should open, the spool loosened and the
tension will release with a popping sound.
3) Continue to pull on the line till there is little tension left.
Slide the remaining line out of the ratchet.
Note: Hold the ratchet in a completely flat position to unlock it.
This is the only way to release the webbing.